Terminate the data wires on the appropriate terminal blocks – Please note that the only the ‘A’ and ‘B’ terminal wires should be connected on the UC and the GND terminal is left without any wires connected. Any wires connected to the ground or GND will be considered a drain wire that could short out the keypad overtime. Be sure to coil and tape any other exposed wires because failure to do so can cause a ground differential and increase the possibility of lightning or surge-related failure. Ensure that all wires are terminated as follows:
- Terminate the 12 VDC power supply wires
- Terminate the USB PC communication cable from the UltraConverter to an available USB port on the management computer
- PLEASE PAY SPECIAL ATTENTION TO THE GROUNDING REQUIREMENTS FOR THIS DEVICE! A detailed diagram is available. Not properly grounding this device can cause premature failure.
- Please see wiring diagrams if there are any questions or concerns\
After you mount and power up the UltraConverter and keypads you are now ready to try and establish communication with the keypads and setup the gate operation parameters.